Checking Speed And Duplex On A Cisco Catalyst 4000 L3 Switch Port
I was asked to check the speed on a Cisco Catalyst 4000 L3 Switch Port.
Username: user01
Enter PASSCODE:
switch01#en
Password:
switch01##show version
Cisco IOS Software, Catalyst 4000 L3 Switch Software (cat4000-I5S-M), Version 12 .2(25)EWA2, RELEASE SOFTWARE (fc2)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2005 by Cisco Systems, Inc.
Compiled Tue 05-Jul-05 13:05 by ccai
Image text-base: 0x10000000, data-base: 0x114DD0D4
ROM: 12.2(20r)EW1
Dagobah Revision 95, Swamp Revision 6
switch01 uptime is 46 weeks, 2 days, 6 hours, 21 minutes
Uptime for this control processor is 46 weeks, 2 days, 6 hours, 32 minutes
System returned to ROM by power-on
System restarted at 07:48:07 EDT Sat Sep 17 2005
System image file is "bootflash:"
cisco WS-C4510R (MPC8245) processor (revision 8) with 524288K bytes of memory.
Processor board ID FOX00000000
MPC8245 CPU at 400Mhz, Supervisor V
Last reset from PowerUp
2 Virtual Ethernet interfaces
288 FastEthernet interfaces
2 Gigabit Ethernet interfaces
511K bytes of non-volatile configuration memory.
Configuration register is 0x2101
switch01##show interfaces fastEthernet 7/29
FastEthernet7/29 is up, line protocol is up (connected)
Hardware is Fast Ethernet Port, address is 0014.a915.b1cc (bia 0014.a915.b1cc)
MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 100Mb/s, link type is auto, media type is 10/100BaseTX
input flow-control is unsupported output flow-control is unsupported
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output never, output hang never
Last clearing of "show interface" counters 8w5d
Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 10000 bits/sec, 11 packets/sec
5 minute output rate 29000 bits/sec, 13 packets/sec
29397779 packets input, 17656391723 bytes, 0 no buffer
Received 17341 broadcasts (270 multicast)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 input packets with dribble condition detected
44211266 packets output, 27434551259 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
switch01##show run interface fastethernet 7/29
Building configuration...
Current configuration : 135 bytes
!
interface FastEthernet7/29
switchport access vlan 40
switchport mode access
no snmp trap link-status
spanning-tree portfast
end
switch01#
The Cisco Catalyst® 4000 Series of modular switches include the Cisco Catalyst 4003 and Catalyst 4006 chassis. As a key component of Cisco AVVID (Architecture for Voice, Video, and Integrated Data), the Cisco Catalyst 4000 Series extends control from the backbone to the network edge with intelligent network services including advanced quality of service (QoS), scalable performance, comprehensive security, and simple manageability.

Leave a comment