PHOTODRW.exe has generated errors and will be closed by windows

check this solution. PROBLEM: In windows 2000 Photo Draw will not start after Windows Service Pack 4 has been loaded. When trying to start Photo Draw a Program Error is created: "PHOTODRW.exe has generated errors and will be closed by Windows. You Will need to restart the program."

SOLUTION STEP 1: Enable Compatibility Mode Properties
1.Log on as Administrator or be a member of the
Administrators Group.
2.Click Start, and then click Run.
3.In the Open box, type the following command, and then
click OK, where %SystemRoot% is the drive and folder in
which Windows is installed:
regsvr32 %systemroot%\apppatch\slayerui.dll

STEP 2: Use Compatibility Mode Properties
Administrators can use a program shortcut to set the compatibility mode for a target program. This requires that the Compatibility-mode properties be correctly installed and registered on the computer by using the previous steps. To enable Compatibility mode by using a program shortcut:
1.Log on as Administrator or be a member of the
Administrators Group.
2.Right-click the shortcut, and then click Properties.
3.Click Compatibility. This tab appears only if the
Compatibility-mode interface has been properly enabled on the computer.
4.Click to select the Run in Compatibility Mode check box to enable Compatibility-mode support for the program.
5.Click Windows 98 compatibility mode in the drop-down box.
6.Click OK to save the changes.
7.Double-click the shortcut to run the program.

NOTE: Be careful if you use Compatibility mode to bypass version warnings in Setup or installation programs. Some programs are designed for a specific operating system and intentionally prohibit use on future versions. These are frequently system-level programs that run at a very low
level and have the potential to cause serious problems if installed.